Removable chassis for the KR Princess LO hilt

With this chassis, you do NOT have to shorten the screws in the hilt, saved the trouble and adapted the chassis around that issue 😉

Also available from the JimmysSaberJunk Shapeways store for super professional prints.
https://www.shapeways.com/shops/jimmy-s-lightsaber-junk?section=KR+Princess+LO&s=0

This is a removable battery design.The battery terminals that are required for this chassis design are included with your purchase.

There are two different PCB Connector options for this chassis
1) Shamino PCB (Combination Pixel and Switch PCB set)
2) Shtok PCB (ShtokCustomWorx Rotary NeoPixel & 2 Button PCB Connector Set)

This chassis is designed for use with:
-ProffieBoard, GHv3 or Verso (select from drop down menu – board not included)
-28mm Bass speaker (not included)
—- Purchase Here: https://www.etsy.com/listing/834078758/sw-28mm-bass-speaker-2w-4ohm
-18650 Lithium Ion Battery (not included)
-High amp kill switch (not included)
—- Purchase Here: https://www.etsy.com/listing/885094580/on-off-slide-switch
-PCB Connector options (select from drop down menu – not included)
—- Shamino’s: https://www.etsy.com/listing/856782474/combination-pixel-and-switch-pcb-set
—- Shtok: https://thesaberarmory.com/collections/shtokcustomworx/products/shtokcustomworx-rotary-neopixel-2-button-pcb-connector-set

This design allows for the board to slide into place once wired up and tested.
After wires are soldered to the battery tabs, I suggest carefully heating up the battery tabs to insert them in to the chassis. This not only makes it a lot easier to insert them, but also forms the plastic around them, holding them far better.
The printed switch housing part is designed to be a goodish fit around the switch assembly of the hilt and correct wire assembly can actually retain this part, but if you still want to add extra security, a tiny bit of double sided tape to the roof you hilt will grab it too.

This is printed using PLA plastic. Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.