*Designed for the Hatson Factor stock tank and shroud.
*3d designed and 3d printed Carbon Fiber reinforced polycarbonate.
includes barrel band and m3 Allen head screw and nut to affix.

*This is intended to correct barrel droop that can happen and keep the barrel equal height off-air cylinder and helps raise a point of impact on your scope if you run out of elevation due
to it drooping too low and just want something more stable than a free-floating barrel, I recommend using a barrel band of some sort if not this one I designed.
*Instructions, From, split gently open and slide to the desired position over the barrel and air cylinder slide to where you would like to mount
* Insert the m3 screw and tighten it down to snug (the nut is affixed to aid in installation) just until the screw reaches the end of the nut. I do recommend taking time as to not scratch
the barrel shroud highly unlikely but in the event, I can’t be held responsible.
*These are very durable but will break if you stretch beyond the limits of material I have tested, and they can take quite a bit of abuse once mounted it corrects barrel drops that do
show up on these air rifle barrels.
*I recommend mounting flush to the stock as shown in the image.
*The Air rifle pictured is not included and is only for demonstration of the product, you will receive the barrel band and m3 mounting hardware only.
*All items are individually made and checked defects are highly unlikely.
*Due to it being 3d printed although very high-quality prints there are very small lines very rare and some bumps that are normal.